Intel STL2 ∙Each group is made one-based1 through, Example, 01 00 10, And the beep code will be

STL2 Server Board TPS Basic Input Output System (BIOS)

∙The 8-bit test point is broken down to four 2-bit groups.

∙Each group is made one-based (1 through 4)

∙One to four beeps are generated based on each group’s 2-bit pattern.

Example:

Checkpoint 04Bh will be broken down to:			01 00 10 11
And the beep code will be:			2 – 1 – 3 – 4
		Table 4-24. Standard BIOS Port-80 Codes
CP	Beeps		Reason
02		Verify Real Mode
04		Get Processor type
06		Initialize system hardware
08		Initialize chipset registers with initial POST values
09		Set in POST flag
0A		Initialize Processor registers
0B		Enable Processor cache
0C		Initialize caches to initial POST values
0E		Initialize I/O
0F		Initialize the local bus IDE
10		Initialize Power Management
11		Load alternate registers with initial POST values
12		Restore Processor control word during warm boot
14		Initialize keyboard controller
16	1-2-2-3	BIOS ROM checksum
18		8254 timer initialization
1A		8237 DMA controller initialization
1C		Reset Programmable Interrupt Controller
20	1-3-1-1	Test DRAM refresh
22	1-3-1-3	Test 8742 Keyboard Controller
24		Set ES segment register to 4GB
28	1-3-3-1	Autosize DRAM, system BIOS stops execution here if the BIOS does not detect any usable
		memory DIMMs
2A		Clear 8 MB base RAM
2C	1-3-4-1	Base RAM failure, BIOS stops execution here if entire memory is bad
32		Test Processor bus-clock frequency
34		Test CMOS
35		RAM Initialize alternate chipset registers
36		Warm start shut down
37		Reinitialize the chipset
38		Shadow system BIOS ROM
39		Reinitialize the cache
3A		Autosize cache

Revision 1.0 4-49