Intel STL2 manual Revision, 4-53

STL2 Server Board TPS		Basic Input Output System (BIOS)
Code	Error Message	Failure Description
0230:	System RAM Failed at offset	System RAM error
		Offset address
0231:	Shadow RAM Failed at offset	Shadow RAM Failed
		Offset address
0232:	Extend RAM Failed at address line	Extended RAM failed
		Offset address
0233:	Memory type mixing detected	Memory type mixing detected
0234:	Single – bit ECC error	Memory 1 bit error detected
0235:	Multiple- bit ECC error	Memory multiple-bit error detected
0250:	System battery is dead – Replace and run SETUP	NVRAM battery dead
0251:	System CMOS checksum bad – Default configuration	CMOS checksum error
	used
0252:	Password checksum bad - Passwords cleared
0260:	System timer error	System timer error
0270:	Real time clock error	RTC error
0271:	Check date and time setting	RTC time setting error
02B0:	Diskette drive A error
02B2:	Incorrect Drive A type – run SETUP	Incorrect Drive A type
02D0:	System cache error – Cache disabled	CPU cache error
0B00:	Rebooted during BIOS boot at Post Code
0B1B:	PCI System Error on Bus/Device/Function	PCI system error in Bus/device/Function
0B1C:	PCI Parity Error in Bus/Device/Function	PCI system error in Bus/device/Function
0B50:	CPU#1 with error taken offline	Failed CPU#1 because an error was detected
0B51:	CPU#2 with error taken offline	Failed CPU#2 because an error was detected
0B5F:	Forced to use CPU with error	An error detected in the entire CPU
0B60:	DIMM group #1 has been disabled	Memory error, memory group #1 failed
0B61:	DIMM group #2 has been disabled	Memory error, memory group #2 failed
0B62:	DIMM group #3 has been disabled	Memory error, memory group #3 failed
0B63:	DIMM group #4 has been disabled	Memory error, memory group #4 failed
0B6F:	DIMM group with error is enabled	An error detected in all the memory
0B70:	The error occurred during temperature sensor reading	Error while detecting a temperature failure.
0B71:	System temperature out of the range	Temperature error detected.
0B74:	The error occurred during voltage sensor reading	Error while detecting voltage
0B75:	System voltage out of the range	System voltage error
0B7C:	The error occurred during redundant power module	The error occurred while retrieving the power
	confirmation	information
0B80:	BMC Memory Test Failed	BMC device (chip) failed
0B81:	BMC Firmware Code Area CRC check failed
0B82:	BMC core Hardware failure
0B83:	BMC IBF or OBF check failed	Access to BMC address failed
0B90:	BMC Platform Information Area corrupted.	BMC device(chip) failed
0B91:	BMC update firmware corrupted.
0B92:	Internal Use Area of BMC FRU corrupted.	SROM storing chassis information failed
		(Available for use except for FRU command
		and EMP function)

Revision 1.0 4-53