ADDENDUM TO ISSUE 4 OF THE AXXESS MANUALOCTOBER 1997
Page 66 of 73

Canadian Information

The AXXESS System has been tested and certified for
installation in Canada. Following is a list of Industry
Canadaregulations which are similar to the FCC regu-
lations already included in the manual.
INDUSTRY CANADA REGULATIONS
NOTICE: The Industry Canada label identifi es certi-
fiedequipment. This certification means that the equip-
ment meets certain telecommunications network
protective,operational, and safety requirements as pre-
scribedin the appropriate TerminalEquipment Techni-
cal Requirements document(s). It doesnot guarantee
the equipment will operate tothe user’s satisfaction.
1. Before installing this equipment, users should en-
sure that it is permissible to be connected to the
facilitiesof the local telecommunications company.
The equipment must also be installed using an
acceptable method of connection. The customer
should be aware that compliance with the above
conditions may not preventdegradation of service
in some situations.
2. Repairs to certified e quipment should be coordi-
nated by a representative designatedby the suppli-
er. Any repairs or alterations made by the userto
this equipment, or equipment malfunctions, may
give the telecommunicationscompany cause to re-
quest the user to disconnectthe equipment.
3. Users should ensure for their own protection that
theelectrical groundconnections of the powerutil-
ity,telephone lines and internal metallic water pipe
system,if present, are connected together. This pre-
cautionmay be particularly important in rural areas.
CAUTION:Users should not attempt to make such
connections themselves, but should contact the
appropriateelectric inspectionauthority, orelectri-
cian, as appropriate.
4. The Ringer Equivalence Number (REN) of this
device is:
1.1
NOTICE: The REN assignedto each terminal de-
vice provides an indication of the maximum num-
ber of terminals allowed to be connected to a tele-
phone interface. The termination on an interface
may consistof any combination of devices subject
only to the requirement thatthe sum of the Ringer
Equivalence Numbers of all the devices doesnot
exceed 5.
5. The standard connecting arrangementcodes for this
equipment are:
CA11A
CA21A
CA81A
CA48C