SECTION 6—ARMS
Removing/Installing Arm Tube
NOTE: For this procedure, refer to FIGURE 6.3.
Removing
1.If needed, remove the joystick. Refer to Removing/Installing the Joystick on page 41.
2.Remove arm pad. Refer to Removing/Installing Arm Pads on page 37.
3.Remove the mounting bolt, two nylon spacers, three coved washers, locknut, and washer attaching arm tube to rear seat tube.
4.Repeat for other arm tube if necessary.
Installing
1.Secure the arm tube to the rear seat tube with the mounting bolt, two nylon spacers, three coved washers, locknut, and washer. Securely tighten.
2.Install the arm pad. Refer to Removing/Installing Arm Pads on page 37.
3.If needed, install the joystick. Refer to Removing/Installing the Joystick on page 41.
DETAIL “A” -
BOTTOM VIEW
| Mounting | Coved Washer |
|
|
| Outside | |
| Bolt |
| |
| Arm Tube Frame | ||
|
| ||
| Nylon |
|
|
| Spacers |
|
|
|
| Coved Washers | |
|
| Washer | Inside |
Full Frame |
| Frame | |
|
| ||
|
|
| |
Back Frame | Back Frame Locknut |
| |
Arm Pad |
|
|
|
Arm Tube |
|
|
|
Bracket |
|
|
|
Front Seat Tube | Rear Seat Tube |
|
|
FIGURE 6.3 Removing/Installing Arm Tube
Part No. 1125078 | 39 | At’m and At’m QT |
