SECTION 9—MOTORS

Removing/Installing Motor Shroud

NOTE: For this procedure, refer to FIGURE 9.2.

Removing

1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.

2.Remove the battery pack/box. Refer to Removing/Installing the Battery Pack on the At’m on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.

3.Remove the seat. Refer to Removing/Installing the Seat on page 31.

4.Remove the three mounting screws that secure the motor shroud to the base frame and base plate.

5.Pull the motor shroud out from around the base frame and lift out.

Installing

1.Position the motor shroud over the motors.

2.Secure the shroud to the base frame and base plate with three mounting screws. Securely tighten.

3.Install the seat. Refer to Removing/Installing the Seat on page 31.

4.Install the battery pack/box. Refer to Removing/Installing the Battery Pack on the At’m on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.

5.Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.

Base Frame

Mounting Screws

Base Plate

Motor Shroud

Motors

NOTE: Drive Wheels not shown for clarity.

FIGURE 9.2 Removing/Installing Motor Shroud

Part No. 1125078

57

At’m and At’m QT

Page 57
Image 57
Invacare 1125078 service manual Removing/Installing Motor Shroud