Invacare 1125078 Adjusting Footrest Height, Installing/Removing the Front Rigging Assembly

SECTION 10—FRONT RIGGINGS

Removing

1.Push the front rigging release lever inward while rotating the front rigging assembly outward.

2.Lift the front rigging assembly out of the front rigging support bracket.

3.Repeat STEPS 1-2 for the other front rigging assembly, if necessary.

	Mounting Pin
Seat Frame Tube	Front Rigging
	Assembly
Inside of	Outside of
Wheelchair	Wheelchair

Front Rigging

Release Lever

Footrest

Front Rigging

Support Bracket

FIGURE 10.2 Installing/Removing the Front Rigging Assembly

Adjusting Footrest Height

NOTE: For this procedure, refer to FIGURE 10.3.

1.Remove the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 65.

2.Remove the hex screw and coved spacer.

3.Move the footrest with slide tube up or down on its mounting tube until the desired footrest height is achieved.

4.Install the hex screw and coved spacer through the front rigging upper support and the slide tube. Securely tighten.

5.Install the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 65.

6.Repeat STEPS 1-5 for the other side, if necessary.

Hex	Front Rigging
Screw	Upper Support

Slide

Tube

Coved

Spacer

Footrest

FIGURE 10.3 Adjusting Footrest Height

At’m and At’m QT 66 Part No. 1125078