Invacare 1125078 service manual Installing/Removing the Front Rigging Assembly, Front Riggings

	SECTION 10—FRONT RIGGINGS
Seat Frame Tube	New Mounting

Spacer	Screw
		Locknut
Locknut
		Spacer
Existing Mounting		Coved Washers
Screw
		Front Rigging
	Spacer	Support
		Bracket
	Front Seat
	Support
	Tube
	Seat Frame Tube

*Large Mounting Hole

Spacer

Mounting Holes

on Front Riggings Support Bracket

DETAIL “A”

*Small Mounting Hole	Front Rigging
	Support Bracket

Front Seat

Support Tube

*NOTE: Mounting hole arrangement on 16-inch wide seat shown. On the 18-inch wide seat, the mounting hole positions are reversed.

FIGURE 10.1 Installing/Removing the Front Rigging Support Brackets

Installing/Removing the Front Rigging Assembly

NOTE: For this procedure, refer to FIGURE 10.2 on page 66.

Installing

1.Turn the front rigging assembly to the side (open footrest is perpendicular to the wheelchair).

2.Insert the mounting pin on the front rigging assembly into the front rigging support bracket.

3.Rotate the front rigging assembly towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be facing the inside of the wheelchair when locked in place.

4.Repeat STEPS 1-3 for the other front rigging assembly.

5.If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on page 66.

Part No. 1125078 65 At’m and At’m QT