Invacare 1125078 service manual Replacing Clothing Guard, Removing/Installing Arm Pads

SECTION 6—ARMS

DETAIL “A”

Locknuts

Washers		Arm
		Bracket
Mounting
Bolts		Rear
Front Seat	Nylon	Seat
		Tube
Tube	Washers

DETAIL “B”
Arm Tube	Arm
Arm	Pad
Bracket

Washers

Mounting

Screw

NOTE: Clothing guard not shown for clarity.

FIGURE 6.1 Removing/Installing Arm Pads

Replacing Clothing Guard

NOTE: For this procedure, refer to FIGURE 6.1 and FIGURE 6.2.

1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.

2.Remove the two mounting bolts, four nylon washers, two locknuts and steel washers that secure the arm bracket to the front and rear seat tubes (Detail “A” of FIGURE 6.1).

3.Lift up arm tube.

4.Slide the clothing guard off the front and rear seat tubes (FIGURE 6.2).

5.Slide the new clothing guard onto the front and back seat tubes.

NOTE: The mesh side of the clothing guard should face out.

6. Lower the arm tube.

Arm Tube

Arm

Bracket

7.Align the mounting holes in the arm bracket with those in the front and rear seat tubes.

8.Secure the arm bracket to front and back seat tubes with the two mounting bolts, four nylon washers, two locknuts and steel washers (FIGURE 6.1).

9.Repeat STEPS 2 to 8 for the other side.

10.Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.

Clothing

Guard

Front Seat	Rear Seat
Tube	Tube

FIGURE 6.2 Replacing Clothing Guard

At’m and At’m QT 38 Part No. 1125078