SECTION 9—MOTORS
4.Install the battery pack/box. Refer to Removing/Installing the Battery Pack on the At’m on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.
5.Install the seat. Refer to Removing/Installing the Seat on page 31.
6.Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.
Removing/Installing MK5 Controller
NOTE: For this procedure, refer to FIGURE 9.4 on page 59 and FIGURE 9.5 on page 60.
Removing
1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.
2.Remove the battery pack/box. Refer to Removing/Installing the Battery Pack on the At’m on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.
3.Remove the seat. Refer to Removing/Installing the Seat on page 31.
4.Remove the motor shroud. Refer to Removing/Installing Motor Shroud on page 57.
5.From the controller, unplug the following connectors (not shown):
A.The joystick connector
B.The battery connector
C.The right motor connector
D.The left motor connector
6.Remove the two mounting screws and coved washers that secure the controller to the base frame.
DETAIL “A” | Base Plate |
DETAIL “B”
Coved
Base
Frame
Base Plate | MK5 Controller |
Washer
Coved
Washer
Mounting Screws | MK5 Controller |
|
NOTE: Motors, drive wheels, and connectors not shown.
Mounting Screws
Base Frame
FIGURE 9.4 Removing/Installing MK5 Controller
Part No. 1125078 | 59 | At’m and At’m QT |
