Invacare 1125078 service manual Resetting the Circuit Breaker, At’m

SECTION 8—BATTERIES

Charger Plugged Directly to Batteries - At’m QT Only

NOTE: For this procedure, refer to FIGURE 8.9.

1.If necessary, remove the battery box from the wheelchair. Refer to Removing/Installing the Battery Box on the At’m QT on page 46.

2.Slide the charger port cap (located on the battery box) to one side.

3.Plug the charger connector into the charger port located on the battery box (FIGURE 8.9).

4.Plug the charger power cord into 110-volt wall outlet.

AC Power Cord

Independent Charger	Plug into Wall Outlet
	Battery Box

3-Pin Charger Connector

Charger Port on Battery Box

FIGURE 8.9 Charging Using an Independent Charger - Charger Plugged Directly to Batteries

- At’m QT Only

Resetting the Circuit Breaker

WARNING

NEVER defeat or bypass the circuit breaker. Only replace with a circuit breaker of the same rating.

At’m

NOTE: For this procedure, refer to FIGURE 8.10 on page 55.

1.Remove the battery pack from the wheelchair base. Refer to Removing/Installing the Battery Pack on the At’m on page 40.

2.Open the battery pack by performing the following -

A.Grasp the side flaps and pull up.

B.Grasp the front flap and pull up.

At’m and At’m QT 54 Part No. 1125078