SECTION
Installing the Battery Module
NOTE: For this procedure, refer to FIGURE 6.1 on page 20.
1.Raise unit handle to upright position.
2.With battery pack label facing toward the transportable oxygen concentrator, slowly lower battery module straight down into battery recess located on back side of the transportable oxygen concentrator.
3.Approximately halfway down, ensure side ribs on battery module have engaged with matching slots on back side of the transportable oxygen concentrator.
4.Continue lowering battery module into place, pressing firmly to ensure contact with battery connections located on the transportable oxygen concentrator.
NOTE: DO NOT slam or force battery module into place, damage to battery connections may occur.
5.Ensure battery module has engaged. Battery gauge and percentage will no longer read zero. Refer to Checking Battery Charge Level on page 22.
Charging the Battery
NOTE: For this procedure, refer to FIGURE 6.1 on page 20.
1.To charge the battery module, make sure the module is fully seated on the unit.
2.Perform one of the following:
•Connect the DC power cable (DETAIL “B”).
•Connect the AC power adapter (DETAIL “C”).
3.Turn off the unit for fastest charge time. Charging times are extended if unit is operating.
NOTE: DC power input may not be sufficient to charge battery at all settings if unit is operating.
NOTE: If the battery is completely discharged, it will fully charge in approximately 4 to 5 hours. During regular use of the transportable oxygen concentrator, it is recommended to recharge the battery, even if only partially depleted, as often as possible.
Battery Time Management
Time away from home is almost limitless by combining the use of the AC power supply, DC power cable and battery modules. To ensure the batteries maintain their optimal charge level, utilize the AC power supply whenever you have access to electric power. Utilize the DC power supply whenever you are in a vehicle.
Part No 1156872 | 21 | Invacare SOLO2™ |
