About This Guide

Who Should Use This Guide

This DataSafe NAS User’s Manual is intended to help setup, configure, and maintain DataSafe NAS. It assumes that you are somewhat familiar with networking and system administration basics.

Overview

Your DataSafe NAS comes ready to install with all the required software. It works in a 10/100 Mbps Ethernet network (or Gigabit Ethernet network when so equipped), and is administered using an Internet Explorer web browser. It includes DataSafe Wizard, Iomega’s software utility that helps you locate the unit on your network, configure DataSafe NAS network settings, and launch the web user interface.

Equipment Required for Administration

To connect, install and administer your DataSafe NAS, you will need an available 10/100 Ethernet network hub or switch. It will also be necessary for your workstation to have the following capabilities:

nWindows 95/98/Me/NT (SP5)/2000

nInternet Explorer v4.01 SP1 or newer - support for Netscape is not currently available.

nClient for Microsoft Networks enabled over TCP/IP.

nNetwork Interface Card (NIC)

nCD-ROM Drive

DataSafe NAS User’s Manual

1

Page 7
Image 7
Iomega Network Device manual About This Guide, Who Should Use This Guide, Overview, Equipment Required for Administration