Page 17

TM-4200GE Software

FIGURE 19. Offset Level.

3.4.8Look-Up Table

The look-up table (LUT) control, shown in Figure 20, allows you to change two knee point values.

FIGURE 20. Look-Up Table

Enter X1, Y1, X2, Y2 values directly to adjust the knee curve. In the integrated camera software, the look-up table can also be controlled interactively. The Table Selection pull-down menu allows you to select the Linear or Gamma 45 option. This control also allows you to check the positive or negative box to choose an image option. There is no LUT for 12-bit output.

3.4.9Memory Pages

All the camera parameters such as shutter mode, shutter speed, gain, offset level, scan mode, and LUT can be saved into seven available memory pages on the EEPROM in the camera. The pages are numbered 0-6. The Load Page button loads the corresponding camera settings from the EEPROM while the write page button writes the current camera settings to the corresponding memory page in the

EEPROM.

Page 1, shown in Figure 21, is the power-up default page. Page 0 is the factory default. To save your current camera settings for power up default, write the settings to memory page 1.

Configuring the TM-4200GE Camera

Page 29
Image 29
JAI TMC-4200GE operation manual Look-Up Table, Memory Pages