Page 49

TM-4200GE Hardware

8.2.2 (b) Ethernet Connector

The GigE socket, marked on the camera’s back panel as GigE, is a standard

RJ-45 Ethernet socket as shown in Figure 50.

FIGURE 50. GigE Ethernet Connector

GigE

Use at least cat5e UTP cables (cat6 cables are preferred). Refer to the Cam2Net User’s Manual for details. JAI Inc. recommends the use of shielded cables to reduce emissions and for CE/FCC compliance. Double-shielded cables further reduce emissions.

8.2.3Power Supplies and Power Cable Setup

8.2.3 (a) Power Supplies

The TM-4200GE camera requires 12V DC power that is obtained through the 12-pin connector located on the rear panel of the camera. JAI Inc. recommends the following power supplies:

PD-12UU

100-240V AC/12V DC

1.2A universal voltage power supply,

 

 

US Plug

PD-12UUP

PD-12UU with12-pin connector

US plug

PD-12UE

PD-12UU

European plug

PD-12UEP

PD-12UU with 12-pin connector

European plug

For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP power supplies are available with the 12-pin mating connector already attached to the leads from the power supply. The PD-12UU and PD-12UE power supplies can be connected to the JAI Inc. power cable either directly or using a terminal strip.

When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:

The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and shorting.

The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

All connections must be properly insulated to prevent shorting.

Installation

Page 61
Image 61
JAI TMC-4200GE operation manual Power Supplies and Power Cable Setup, Ethernet Connector