JAI TMC-4200GE Channel Balance, Vsub, Dual Tap Digital Video Output Order, Image Pre-processing

Page 28

TM-4200GE Software

Command	Parameter	End of	Ack. Response	Description
		Cmd
Lookup Table
:LINR		<cr>	:o<cr>	Set linear table
:GM45		<cr>	:o<cr>	Set gamma .45 table
:KNEE=	X1Y1X2Y2	<cr>	:o<cr>	Set knees
				(X1, Y1, X2, Y2 = 00 - FF)
:NLUT	X	<cr>	:o<cr>	Set Positive Knee or Negative Knee (X =
				0 Positive, X = 1
				Negative)
:LUT?		<cr>	:o[lut]<cr>	Inquire current LUT setting
Channel Balance
:EABL		<cr>	:oAB0<cr>	Enable Gain Balancing
:DABL		<cr>	:o<cr>	Disable Gain Balancing
:ABL?		<cr>	:oAB[X]<cr>	Check Gain Balancing Status
				(X = 1 Enable, X = 0 Disable)
:ACL=	X	<cr>	:o[AC][X]<cr>	Enable/Disable Optical Black Balancing
				and Inquire Status
				(X = 0 Disable, X = 1 Enable,
				X = ? Inquire Status)
Vsub
:DCI=	XXX	<cr>	:o<cr>	Set Vsub (XXX = 600 - D00)
:DCI?		<cr>	:oDC[XXX]<cr>	Inquire Vsub (XXX = 600 - D00)
Command	Parameter	End of	Ack. Response	Description
		Cmd
EEPROM
:WRPG	X	<cr>	:o<cr>	Write Page (X = 0 - 6) (Unlock the Pass-
				word first if writing to page 0) (Page 0 is
				the factory default setting, Page 1 is the
				power up default setting)
:LDPG	X	<cr>	:o<cr>	Load Page (X = 0 - 6)
:RDPG	X	<cr>	:o[settings]<cr>	Read Page (X = 0 - 6)
:RPST		<cr>	:o[settings]<cr>	Report Current Settings
Dual Tap Digital Video Output Order
:VDO	X	<cr>	:o[VD][X]<cr>	Set Dual Tap Digital Video Output Order
				(X = A, B, C, ?)
				(A <--<--, B <---->, C <<----, ? Inquire
				video output order)
Image Pre-processing
:BLC=	0	<cr>	:o<cr>	Set White Blemish Calibration Flag
:EBL=	X	<cr>	:o[BL][X]<cr>	Enable/Disable Blemish Compensation
				and Inquire Status
				(X = 0 Disable, X = 1 Enable,
				X = ? Inquire Status)

GigE Series Camera Serial Commands