JAI TMC-4200GE Dual-Tap TM-4200GE AccuPiXEL Series Camera-Control Software, Introduction

Page 32

Dual-Tap TM-4200GE AccuPiXEL Series Camera-Control Software

6.1 Software Installation

Following are the instructions to install the Dual-Tap AccuPiXEL series camera-control software on a PC.

6.1.1Before Installing Dual-Tap AccuPiXEL Series Camera-Control Software

Please note the following requirements.

•Your computer must be running Microsoft Windows NT 4.0, Windows 2000, or Windows XP.

•The software requires one available communication port that is not in conflict with other peripher- als such as the mouse or modem.

•Installation of the software requires 2.4 MB of free space in your PC hard disk.

6.1.2Installing the Software

To install the Dual-Tap AccuPiXEL series camera-control software, obtain the software from the JAI web site and run “Setup.exe.” The installer will direct you to install the application code.

If dual tap software is already installed on your computer, uninstall the software using the steps in the Uninstall section.

1.To obtain the Dual-Tap software visit the JAI Inc. web site at http://www.jai.com

2.Click the Support link

3.Click the Software Downloads link under the Customer Support menu

4.Select the camera model number by clicking in the option button.

5.Select either “Open” or “Save” on the install dialog box

Note:The file is compressed, and uses the decompression program installed on your computer. WinZip is used in this example.Windows XP has an unzip capability as part of the operating system.

6.Open the file.

7.Double click on the JAI Inc. GigE 2.2.0.1 Install icon.

FIGURE 27. The Setup icon installs Dual Tap AccuPIXel v 2.2.x.x

8.Follow the Setup instructions.

Introduction