JAI TMC-4200GE JAI Inc. Power Cables, 12P-02S Interface Cable Pin# Lead Color Function

Page 50

TM-4200GE Hardware

8.2.3 (b) JAI Inc. Power Cables

If you are using JAI Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out diagram below. The cable pin-out diagram is shown in Figure 51. The color-coded leads use Gray for Ground and Yellow for +12V.

FIGURE 51. 12P-02S Interface Cable (optional)

							+12 V
						GND (Gray)
	Male					Power (Yellow)
						Video Out (Red Coax)				Analog Ch. A only
						HD In (White Coax)		}		External sync input
						VD In (Black Coax)
				12P-02S Interface Cable
Pin#			Lead Color	Function	Pin#	Lead Color				Function
1			Gray	GND	7	Black coax			TTL IN (EXT_VD)
2			Yellow	+12V DC	8	White coax shield			TTL OUT (STROBE)
3			Red coax shield	GND(analog)	9	White coax			TTL IN (EXT_HD)
4			Red coax	RESV	10	Brown				Reserved
5		Orange coax shield		GND(Digital)	11	Blue				Reserved
6			Orange coax	TTL IN (EXT_TRIG)	12	Black coax shield				Reserved

Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires could cause the leads to short.

8.2.3 (c) Building Your Own Power Cable

Refer to the 12-pin connector pin-out in Figure 49 on page 48. Connect the Ground lead to pin #1, and the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient current to properly power the camera.

8.2.3 (d) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly attach the power cable to the camera connector:

1.Rotate the connector while applying slight pressure until the keyways line up.

2.Press the connector into place until firmly seated.

3.Plug the power cord into the 100V AC socket. This powers-up the camera.

Installation