JAI TMC-4200GE operation manual Pulse Generators, Gpio Look-Up Table Output Labels

Page 25

TM-4200GE Software

Input	Signal	Description
Label
I5	CTRL0	Internal control signal.
	PULSE_GEN2	Pulse Generator 2 signals go here.
I6	PULSE_GEN1	Pulse Generator 1 signals go here.
	N/A
I7	PULSE_GEN0	Pulse Generator 0 signals go here.
	N/A

Table 3 shows which output labels carry the output signals.

TABLE 3. GPIO Look-Up Table Output Labels

Output label	Signal	Description
Q0	TTL-OUT(STROBE)	Strobe output
Q1	N/A
Q2	N/A
Q3	N/A
Q4	EVINIT	Trigger
Q5	INTG_CON	Integration control
Q6	EXT_VD	Vertical Drive
Q7	EXT_HD	Horizontal Drive
Q8	pulse_trig1	Pulse Generator 1 gets its trigger here
Q9	pulse_trig0	Pulse Generator 0 gets its trigger here
Q10	pulse_trig3	Pulse Generator 3 gets its trigger here
Q11	pulse_trig2	Pulse Generator 2 gets its trigger here
Q12	N/A
Q13	N/A
Q14	TRIG	Trigger for camera’s internal frame grabber
Q15	RESV	Reserved

4.5 Pulse Generators

The TM-4200GE camera has four independently programmable pulse generators. These generators can run as either periodic or triggered. To run the pulse generators as triggered, they can be triggered on either levels or signal edges. These generators can be tied to the camera inputs (camera-control lines). For example, you can set pulse generator 0 in the Device Features tabbed dialog box to the following values:

Delay = 600

Width = 14,000

Signal Handling