JAI TMC-4200GE GigE Series Camera Serial Commands, TM/TMC-4200 Command List, Scan Mode

Page 27

TM-4200GE Software

5 GigE Series Camera Serial Commands

You can control the GigE series cameras by serial command either using RS-232 or Camera Link. The Start character is always “:” and the End character is always <CR> (return). For example, to set Asynchronous Pulse Width Mode, send the command :ASH=9<CR> to the camera. Table 4 lists serial commands that can be used to control the camera.

TABLE 4. TM/TMC-4200 Command List

Command	Parameter	End of	Ack. Response	Description
		Cmd
Scan Mode
:SMD	X	<cr>	:o<cr>	Set Preset Scan Area (X=A,B,C,D,T)
:SMDZ=	X	<cr>	:o<cr>	Set Digital Zoom (X=0,1,2,3)
:SMDU=	XXXXYYYY	<cr>	:o<cr>	Set Programmable Scan Area
				(XXXX=0000 - 07FF, YYYY=0001 -
				0800)
:SMD?		<cr>	:oMD[X]<cr>	Inquire current scan mode
				(X=A,B,C,D,T,Z,U)
Shutter Mode and Shutter Speed
:MSH=	X	<cr>	:o<cr>	Set Continuous Mode Preset Shutter ( X=
				0 - 9)
:DSH=	XXX	<cr>	:o<cr>	Set Continuous Mode Programmable
				Shutter ( XXX=000 - total lines)
:ASH=	X	<cr>	:o<cr>	Set Async Mode Preset Shutter (X=0 - 9,
				A, B) ( X=0 async no shutter,
				( X=1-8 Preset Shutter, X=9 PWC, X=A
				Fixed exposure PIV, X=B PWC PIV)
:ADS=	XXX	<cr>	:o<cr>	Set Async Mode Programmable Shutter
				(XXX=000 - 81F)
:SHR?		<cr>	:o[shtr]<cr>	Inquire current shutter mode
Gain and Offset
:MGA=	XXX	<cr>	:o<cr>	Set Master Gain
				(XXX = 000 - FFF)
:MGB=	XXX	<cr>	:o<cr>	Set R channel Fine Gain
				(XXX = 000 - FFF)
:VRA=	XXX	<cr>	:o<cr>	Set Master Offset
				(XXX = 000 - FFF)
:VRB=	XXX	<cr>	:o<cr>	Set R channel Fine Offset
				(XXX = 000 - FFF)
:MGA?		<cr>	:oMG[XXX]<cr	Inquire Master Gain
			>	(XXX = 000 - FFF)
:MGB?		<cr>	:oSG[XXX]<cr>	Inquire R channel Fine Gain (XXX = 000
				- FFF)
:VRA?		<cr>	:oMF[XXX]<cr>	Inquire Master Offset
				(XXX = 000 - FFF)
:VRB?		<cr>	:oSF[XXX]<cr>	Inquire R channel Fine Offset
				(XXX = 000 - FFF)

GigE Series Camera Serial Commands