JAI TMC-4200GE operation manual Quick-Start, Change and Remove Buttons

Page 4

TM-4200GE Software

3.Click the Change or Remove button as shown in Figure 3 on page 4.

FIGURE 3. Change and Remove Buttons

1.4.4Quick-Start

Use the following quick-start process when the Camera Interface Application is installed on your PC.

1.Connect the camera. The Hirose pin layout is shown in Table 1 on page 6. Both the Hirose and the network cable (RJ-45) are illustrated in Figure 6. Verify that both LED’s on the RJ-45 connector are green.

2.Run the Camera Interface Application.

3.Click Detect. Assign a suitable IP address to the camera. The window shown in Figure 2 appears.

FIGURE 4. Network Device Finder Window

4.Select the appropriate camera from the list, similar to the window shown in Figure 5 on page 5 and click OK.

Software Introduction