JVC KY-F1030U manual Pin configurations of connectors, DC in terminal Mini DIN 8-pin, female, E12

1. Introduction (continued)

Pin configurations of connectors

DC IN terminal (Mini DIN 8-pin, female)

			7
	8			6
	5		3
		2	4
			1
Pin no.			Signal name
1	NC
2	GND
3	NC
4	NC
5	GND
6	12V
7	NC
8	12V

LENS terminal (Metal 12-pin, female)

	9	10	1
	8		2
	7		3
	6		4
	12	5	11
Pin no.		Signal name
1	NC
2	NC
3	GND
4	NC
5	IRIS CONTROL
6	12V DC 400mA max.
7	IRIS POSITION
8	IRIS AUTO /MANU
9 to 12	NC

CAUTION

Use device whose current consumption is max.

400 mA or less.

REMOTE terminal (Metal 10-pin, female)

	8	1
	7	2
	10	9
	6	3
	5	4
Pin no.		Signal name
1	A. WHITE L active
2	TRG IN L active
3	WEN L active 3.3V(p-p)
4	FLASH
5	NC
6	RS-SDI
7	RS-SDO
8	GND
9	12V
10	OPERATION

CAUTION

•Consult your JVC dealer concerning the re- mote terminal connection.

•Remote cable must use shielded cable. Outer shield of remote cable must to connect 10-pin connector outer metal shell.

•Do not input the external trigger during the first 5 seconds after the power is turned ON.

Terminal		I/O		Conditions
name
2 TRG IN	IN		• Contact point
	• 3.3V CMOS			recommended
	•	Schmidt Trigger	• Maximum rated
	•	Pull-up to 3.3V at		voltage: 5.3V
		4.7k Ω	•	H level: 2.4 ~ 5.0V
			•	L level: 0 ~ 0.5V
			• Pulse width:
				130 ∝ s or higher
3 WEN	OUT
	•	3.3V (p-p)
		negative polarity
4 FLASH	OUT		• Maximum rated
	•	Open collector		current: 150mA
			• Maximum rated
				voltage: 12V

E12