JVC KY-F1030U manual White spot compensation, How to use, E28, Cation software KY-LINK

4. Shooting a computer monitor screen (cont’d)

White spot compensation

One of the inherent, general characteristics of CCDs is that white spots may appear in the image at slow shutter speeds or during shooting at high temperatures.

To moderate this phenomenon, this camera is provided with a white spot compensation function. In the digital output mode, white spot adjustment should be performed using the special appli-

cation software [KY-LINK].

How to use

White spot detection

Because the number of spots and their size differ with the temperature and shutter speed, etc., it is necessary to detect the positions of the white spots under the conditions of use before the white spot compensation is used.

1.

2.

Make the settings under the conditions at which the unit is to be used (ambient temperature and shutter speed, etc.).

Prevent light from entering the CCD by closing the lens iris, etc.

	Inside window		3.
			［UP］�
		UP/AW
［MENU］�	MENU	SET	［SET］�
		DOWN	［DOWN］
	1 2 3 4		4.

Open the side switch panel, and press the [MENU] but- ton for 2 seconds or longer. The [MENU] screen ap- pears on the monitor screen.

Press the [UP] or [DOWN] button to select [PIXEL CHECK] on the [PROCESS(2/2)] screen, and then press the [SET] button to display the [PIXEL CHECK] screen.

5.

6.

PROCESS (2/2) screen

When the [SET] button is pressed, detection of the po- sitions of white spots starts. The detection may take several minutes.

When the detection is completed, “PIXEL CHECK OK” is displayed for about 3 seconds before the [MENU] screen returns.

PIXEL CHECK screen Screen during detection Screen when detection is completed

E28