JVC KY-F1030U manual Mounting the lens, E17

Mounting the lens

Follow the procedure shown below when mounting a motorized lens. For further details, see the instruction manual of the lens and lens remote control.

4. [MD CONTROL] connector		CAUTION
		• Perform mounting of the lens
Camera head	3. Lock	with the power of the camera
		turned OFF. Mounting with the
Thread section		power on could result in dam-
		age.
Mount clamp ring
		• Lens is not included with this
Lens		unit.
2.	(Female) 4. Lock
	Lens remote control
	Compatible lens	Lens remote controller
Compatible	remote controller
zoom lens	FJINON, RMD-10,
D16⋅ 7.3A-D29	RMD-20

1. Remove the lens mount cap. At this time, take caution so that dust do not enter inside the mount.

2. To mount the lens, lightly press the thread section of the lens mount onto the thread section of KY-F1030, then turn the lens unit or KY-F1030 slowly clockwise until it is securely tight- ened.

MEMO

To change the position of the lens rotation:

￿First, turn the mount clamp ring clockwise (1/4 turns) with the lens facing you.

￿Slowly turn the lens and after adjusting the position, retighten the mount clamp ring.

3.Insert the camera cable of the lens into the [LENS] connection terminal on the rear of KY- F1030, then securely lock.

The iris control is made from the KY-F1030.

4.When using the lens remote controller, connect the lens control cable (female) to the re- mote control. Also, when focusing and zoom controller is to be performed on the KY-F1030, connect the lens control cable (female) to the [MD CONTROL] terminal on the KY-F1030. When operating the lens iris manually by lens remote control connection, set IRIS MODE to manual. (
page E33)

CAUTION

When using a motorized lens, use the AC adapter as power supply for the KY-F1030.

If power is supplied via the [IEEE1394] connector, control of the motorized lens is not possible from the KY-F1030.

E17