JVC KY-F1030U manual Connecting power, Connecting the IEEE1394 Cable, E18

2. Before shooting (continued)

Connecting power

Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA terminal of the AC adapter (AA-P700) connect the power cable (2m) which is provided.

AA-P700 AC adapter

DC 12V=OUTPUT		ANALOG OUT
	VIDEO OUTPUT		IEEE1394
AC 100V
		LENS
S(Y/C) OUTPUT	TO CAMERA
			MD
			CONTROL
EITHER	SEE INST-
OUTPUT	RUCTION	DC IN	REMOTE
MAX 1.25A	MANUAL
		POWER

AC White marking	[TO CAMERA]	SEE INSTRUCTION MANUAL
	connector

[DC IN] connector

Connect the end with	power cable
the white marking to
the AC adapter.	(provided)

DC IN

POWER

Ring

Plug

After inserting the plug com- pletely, tighten the securing ring.

Make sure white indication of power cable comes to AA- P700 side.

CAUTION

•Be sure to use the AA-P700 power supply.

Before connecting power cable, make sure that the power switch on the AA-P700 is set to OFF. Connecting with the power switch on may result in camera malfunction.

•When connected through the digital output (Connecting through digital output connector (page E14)), power can be supplied from the PC but control of a motorized lens and analog output will not be possible.

MEMO

Wait at least 10 seconds before turning the power switch back on, when it has just been turned off. Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc.

Connecting the IEEE1394 Cable

 To reduce the emission of unwanted radio waves, make sure to attach the provided clamp filter as shown in the figure on the left.

Attach the clamp filter as close to the KY-F1030 as possible as shown in the figure.

To [IEEE1394] connector

E18