JVC KY-F1030U manual Settings and adjustments for shooting, Lens settings, Monitor adjustment, E21

3. Settings and adjustments for shooting

Lens settings

Set according to whether the used lens to be used is an auto-iris lens or a manual lens.

Set the used Lens

Set the [IRIS MODE] on the [EXPOSURE] screen. (
page E33)

AUTO : Setting when auto-iris lens is used in auto mode.

MANUAL : Set when using a manual lens, using an auto-iris

lens in MANUAL or no lens.

* If the auto-iris lens cable is not connected to

the [LENS] connector, the setting automatically becomes “MANUAL”.

(Default setting: AUTO)

Monitor adjustment

The colour contrast and brightness are adjusted whilst, built-in test signals of the camera are being displayed on the PC monitor.

[ANALOG OUT]	[IEEE1394]
ANALOG OUT	IEEE1394
LENS
	MD
	CONTROL
DC IN	REMOTE
POWER
SEE INSTRUCTION MANUAL

Inside window
	UP/AW
MENU	SET
	DOWN
1 2	3 4

Default Setting Switch

1. Connect the [ANALOG OUT] connector or the [IEEE1394] connector to the PC.

2. Set the function setting switch NO.1 on the switch panel on the side of the KY-F1030 to “ON”.

ON

OFF 1 2 3 4

3. Turn ON the KY-F1030, and then start the PC.

*When connecting through the [IEEE1394] connector, power is supplied from the PC.

4.Adjust the monitor.

MEMO

•For how to adjust, see the instructions for the employed monitor.

•The peak level of the test signal is set to 0.7V from the fac- tory. To use 0.57V, change the setting by [TEST PATTERN]

➝ [LEVEL] on the [SYSTEM SETTING] screen.

page E40 TEST PATTERN

E21