2. Before recording (continued)

Connecting an MO/Zip® drive

It is possible to output image data stored in the main unit memory to an MO drive or a Zip® drive. (  Page 38 Saving images from the memory to an MO/Zip® disk)

CAUTION

Before connecting, make sure that the power of all sys- tems are turned off. Connecting with the power turned on may result in malfunction.

The MO/Zip® drive must be equipped with a terminator power supply.

Recommended Zip® drive: iomega Zip® 250 (for SCSI connection)

Dip switches

SCSI

SEND

REC

AW/SEL MODE

MENU UP

DOWN SET

 

PLAY

 

FREEZE

MONITOR

LENS

REMOTE

DC IN

ON 1 2 3 4

POWER

SEE INSTRUCTION MANUAL

SCSI terminal

Be sure to terminate the last device on the SCSI bus.

To directly connect the MO drive to the main unit, set the dip switches on the rear of the main unit as shown below.

ON 1 2 3 4

CAUTION

(ID : 7)

Set the ID of the MO drive side to other than 7.

MEMO

Turn on the camera power after turning on the MO/Zip® drive power. Furthermore, reinsert the cam- era power when turning the MO/Zip® drive power off.

Use a formatted DOS/V disk.

Connecting two or more MO/Zip® drives at the same time is not possible. Neither is it possible to connect an MO drive and a Zip® drive at the same time.

The image data outputted to an MO/Zip® drive unit will be 1360 1024 pixels, regardless whether the mode is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT.

The maximum allowed length of the SCSI cable is 3m.

It is not possible to simultaneously output the image data to a printer and MO/Zip® drive.

The image data will be save as uncompressed TIF files (one file approx. 4 megabytes).

E20

Page 24
Image 24
JVC KY-F70B manual Connecting an MO/Zip drive, E20, Scsi terminal