JVC KY-F70B manual E31, Error Over Light excessive light

AW

SCSI

REC

SEND AW/SEL MODE

MENU UP DOWN SET

PLAY

FREEZE

MONITOR LENS

REMOTE	DC IN
ON 1 2 3 4	POWER

SEE INSTRUCTION MANUAL

Auto-white operation area

A U T O W H I T E

O P E R A T I O N

Auto white in operation

AUTO W H I TE

O K

Auto white operation completed

MEMO

7. Press the AW (Auto White) button.

●When auto white is in operation, the auto-white op- eration area and AUTO WHITE OPERATION will be displayed on the monitor screen.

●When the white balance is successfully set, AUTO WHITE OK will appear for about 3 seconds on the screen and the unit will return to the normal screen.

MEMO

•When setting the VGA mode to FINE, using the SXGA mode or setting the unit to a slow shutter speed, the white bal- ance operation may take some time before completion.

•With the factory setting, it may take up to 13 seconds de- pending on the subject. (When setting the shutter speed to

1s takes maximum of 1 minute 45 seconds.)

●Error display

When the auto white balance cannot be set, one of the following error messages will appear and the unit will return to the normal screen.

NG: OBJECT (bad object)

Displayed when the object consists of little whiteness or when the colour temperature is not correct. Change to a white object and redo the white balance.

ERROR: LOW LIGHT (shortage of light)

Displayed when the lighting is too dark. Brighten the lighting and redo the white balance.

ERROR: OVER LIGHT (excessive light)

•Displayed when the lighting is too bright. Close the lens iris or lower the brightness and redo the white balance.

•When the colour temperature of the subject changes as the darkness increases, do not change the illumination. Instead, narrow the lens iris, and take the white balance again by pressing the AW (Auto White) button.

•When a shutter speed exceeding 1 sec is used, it is not possible to launch the auto white balance function.

Temporarily return the shutter setting to below 1 sec and launch the auto white balance function, or set the WHITE BAL item to MANUAL or PRESET.

E31