JVC KY-F70B Outputting images from the memory to a printer, Use a compatible printer.
, E39

Outputting images from the memory to a printer

Use a compatible printer. (
Page 21)

It is possible to directly output images stored in the camera’s memory to a printer connected via the SCSI terminal when in the FREEZE or PLAY mode.

confirmationPrint		PR I NT OUT
		ACCE PT
	SCSI Output mark
		Number of recordable
		shots remaining
		SCSI output image mark

completedPrint	PR I NT OUT
	O K

MEMO

Set to either the FREEZE (
page 36) or PLAY (
page 37) mode.

1. Check to make sure that dip switches 1 and 2 are set to OFF as shown in the diagram on the left (
page 38).

2. Press the SEND button. The data will be sent to the printer and a PRINTOUT ACCEPT message will ap- pear for approximately 3 seconds on the monitor con- nected to the MONITOR terminal.

At this time, SCSI output mark will appear.

3. After data is successfully outputted to the printer, PRINT OUT OK will appear for approximately 3 seconds.

4. If data is not successfully outputted to the printer, one of the following error messages will appear for approxi- mately 3 seconds.

ERROR : SCSI (check the cable)

ERROR : PRINTER (printer error)

•Do not turn off the power of the main unit or other connected devices when the SCSI output mark is displayed.

•Set the SCSI ID of the MO/Zip® drive or printer to other than 7.

•If both MO/Zip® drive and printer are connected to the SCSI terminal, select which source to output to by selecting PRIORITY in the SYSTEM SETTING screen. (
Page 59; default setting: DISK)

•Do not connect devices other than printers MO drives and Zip® drive to the SCSI terminal since correct output will not be achieved. In addition, the connectable number of devices are one printer and one MO drive, or one printer and one Zip® drive.

E39