JVC KY-F70B manual Connecting a printer, E21

Connecting a printer

It is possible to directly output image data stored in the main unit memory to a printer. (
page 39 Outputting images from the memory to a printer)

CAUTION
Before connecting, make sure that the power of all sys-
tems are turned off. Connecting with the power turned on	Dip switches
may result in malfunction.

Use the following printer.

Mitsubishi: CP-700DSU/E, CP-770DW, CP-800DW

CP700DSA MITSUBISHI

PAPER FEED & CUT] COPY ONLINE

ALARM SHEET PAPER DATA

POWER

OPEN

SCSI

SEND	REC
	AW/SEL MODE
MENU UP	DOWN SET
	PLAY
	FREEZE

MONITOR	LENS
REMOTE	DC IN
ON 1 2 3 4	POWER

SEE INSTRUCTION MANUAL

SCSI terminal

•Be sure to terminate the last device on the SCSI bus.

When directly connecting the main unit to a printer, set the dip switches on the rear of the main unit as shown below.

ON 1 2 3 4

CAUTION

(ID : 7) Set the ID of the printer side to other than 7.

MEMO

•Turn on the camera power after turning on the printer power.

•Connecting two or more printers at the same time is not possible.

•The image data outputted to a printer will be 1312 ⋅ 1024 pixels, regardless whether the mode is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT.

•The maximum allowed length of the SCSI cable is 3m.

•When connecting an MO/Zip® drive to a PC, separate setting of the SCSI ID is required.

•It is not possible to simultaneously output the image data to a printer and MO/Zip® drive.

E21