JVC KY-F70B manual Monitor adjustment, E28, On 1 2 3

drive, printer

• Image data cannot be output to an MO/ Zip® or PC while the colour bar is displayed.

4. Turn the camera power to on.

5. Adjust the VGA monitor.

MEMO

• For adjustment of the monitor, see the instruction manual of the monitor.

• The default value of the peak level is set to 0.7 V. To change the setting to 0.58V, select BAR LEVEL in the SYSTEM SET- TING screen. (
Page 60)

• It is not possible to switch between the REC/PLAY modes while the colour bar is displayed.

1. According to the system, set the MONITOR mode to VGA.

3. Settings and adjustments for recording (continued)

Monitor adjustment

The colour contrast and brightness are adjusted whilst, built-in colour bar signals of the camera are being displayed on the PC monitor.

MONITOR terminal

SCSI	ON 1 2 3 4
REC
SEND AW/SEL MODE
MENU UP DOWN SET	Set dip switch no. 3 located on the rear
PLAY	of the camera to OFF.
FREEZE

MONITOR LENS

REMOTE	DC IN	2. Connect the VGA monitor to the MONITOR terminal.
ON 1 2 3 4		POWER
SEE INSTRUCTION MANUAL		3. Set dip switches 4 on the rear of the camera to ON.
		ON 1 2 3 4
Dip switches

E28