JVC KY-F70B manual Pin configurations of connectors, Power terminal Mini DIN 8-pin, female, E12

1. Introduction (continued)

Pin configurations of connectors

Power terminal (Mini DIN 8-pin, female)

			7
	8			6
	5		3
		2	4
			1
Pin no.			Signal name
1	NC
2	GND
3	NC
4	NC
5	GND
6	12V
7	NC
8	12V

Lens terminal (Metal 12-pin, female)

	9	10	1
	8		2
	7		3
	6		4
	12	5	11
Pin no.		Signal name
1	NC
2	FREEZE
3	GND
4	NC
5	IRIS CONTROL
6	12V DC
7	IRIS POSITION
8	IRIS AUTO /MANU
9 to 12	NC

E12

Remote terminal (Metal 10-pin, female)

	8	1
	7	2
	10	9
	6	3
	5	4
Pin no.		Signal name
1	A. WHITE L active Zi=22k Ω
2	FREEZE L active Zi=100k Ω
3	WEN L active Zo=22 Ω 3.3V(p-p)
4	FLASH
5	SEND
6	RS-SDI
7	RS-SDO
8	GND
9	12V
10	OPERATION

CAUTION

•Consult your JVC dealer concerning the re- mote terminal connection.

•Remote cable must use shielded cable.

Outer shield of remote cable must to connect 10-pin connector outer metal shell.

Terminal	I/O	Conditions
name
FREEZE	IN	• Contact point
	• 5V CMOS	recommended
	• Schmidt Trigger	• Maximum rated
	• Pull-up to 5V at	voltage: 5.3V
	100k Ω	• H level: 3.5 ~ 5.0V
		• L level: 0 ~ 0.8V
		• CMOS (5V): OK*
		• TLL not possible
		• Pulse width:
		130 ∝s or higher
WEN	OUT	• Output only when
	• 3.3V (p-p)	in the SXGA mode
	negative polarity
FLASH	OUT	• Maximum rated
	• Open collector	current: 150mA
		• Maximum rated
		voltage: 12V

*However, insert a diode as shown in the dia- gram below.

KY-F70B

C Mos IC