JVC KY-F70B manual E35

White spot compensation

To compensate for the detected white spots, set the PIXEL COMP to ON. (
page 57 PIXEL COMP.)

MEMO

•The camera’s white spot compensation function cannot compensate completely for all white spots. White spot detection and compensation by this camera must be performed under the following con- ditions. White spot compensation is not possible under other con-

ditions. Even when these conditions are met, the properties of the white spots may prevent compensation.

Detection and compensation area: Area of 1024X1024 pixels at the center of the screen.

No. of detections and compensations: Within a total of 15 spots.

•The screen shown on the right may appear if light enters the CCD while white spot detection is being performed, or due to the con- ditions of the white spots. In this case, confirm that light is not entering the CCD. If light is not entering the CCD but the screen nevertheless remain displayed, accelerate the shutter one step and perform the detection again.

P I XE L CHECK

N G

•When white spot compensation is carried out, the compensation

of the pixel data is performed based on surrounding pixel data, which means that accurate data may not be obtained in case of an image with fine details.

•The result of the white spot detection is retained until the next white spot detection is performed.

E35