[PHONES] Terminal

Audio output from the [PHONES] terminal can be selected using [Audio Monitor] in the [A/V Out] menu (A Page 93) as well as the [MONITOR SELECT] switch on the camera recorder.

The different combinations of settings that are output from the [PHONES] terminal and monitor speaker are as follows.

[MONITOR

 

[PHONES]

 

SELECT]

[Audio Monitor]

Terminal

Speaker

Switch

Settings

L

 

R

 

Settings

 

 

 

 

 

 

 

 

[CH-1]

^

CH1

 

CH1

 

 

 

 

[BOTH]

[Mix]

CH1+CH2

CH1+CH2

 

 

 

 

 

 

[Stereo]

CH1

 

CH2

 

 

 

 

 

 

 

[CH-2]

^

CH2

 

CH2

 

 

 

 

 

 

IEEE1394 Connection

“Backup recording ” can be performed, which allows the same image recorded to the SDHC card on the camera recorder to be recorded to the external device connected to the IEEE1394 terminal. (A Page 124)

[IEEE1394] Terminal

Note :

●When connecting the camera recorder to an external device using an IEEE1394 cable, make sure to observe the following. Improper connection may cause the circuit of the connected unit to malfunction.

●Turn off the power of the camera recorder and connected devices before connecting the IEEE1394 cable.

●Do not connect the cable in an environment where static electricity occurs or is likely to occur.

●Make sure that each camera recorder is connected to only one external device at any one time.

●When the video format input from the [IEEE1394] terminal is different from the video format of the camera recorder, a AVIDEO FORMAT INCORRECTB message is displayed. Set according to the video format entered for [System Definition], [Camera Resolution], and

[Frame & Bit Rate] in the [Record Format] menu. (A Page 75)

VIDEO FORMAT

INCORRECT

●If the [INT/EXT] IEEE1394 interface terminal switch is set at AEXTB and the AHQB mode is selected in

[Frame & Bit Rate], signals will not be output from the [IEEE1394] terminal. (A Page 75)

123