Using the Internal Time Code Generator (continued)
Setting User’s Bit Without Opening the MenuMemo :
●Settings cannot be made in the following cases.
●[TCG Source] in the [TC/UB] menu is set to AExternalB.
●[TC GENE.] switch is set to AREGENB.
●Menu screen is displayed.
●The camera recorder is not in Camera mode. (Except AUX mode)
Required Settings Before Preset (A Page 49)
●Set [TCG Source] in the [TC/UB] menu to AInternalB.
●Set the [TC DISPLAY] switch to AUBB.
●Set the [TC GENE.] switch to settings other than AREGENB.
Setting User’s Bit1 Hold down the [MENU] button and press the [USER1] button.
The [UB Preset] setting screen appears.
Cursor
[UB Preset] Screen
2 Set the user’s bit.
Use the
Memo :
●Press the [USER2] button to reset each digit to A0B. The cursor moves to the left.
3 Check the values and press the Set button (R).
●The user’s bit is set and the screen returns to the normal screen.
●To cancel the setting, press the [CANCEL] button.
Note :
●Editing will be canceled and the screen will close under the following situations.
●The [TC DISPLAY] switch is selected during editing.
●The camera recorder is switched to the Media mode.
Note :
●When editing time code, operations of the [USER1], [USER2], [USER3] buttons that are set in the
[Main Menu] B [Camera Function] B [Switch Set] menu are disabled. [USER2] functions as the number reset button. (A Page 79)
Recording Time Code in Continuation of the Recorded Time Code on SDHC cardThis camera recorder is equipped with the time code reader.
[TC GENE.] Setting Switch
1 Set [Main Menu] B [TC/UB] B [TCG Source] to AInternalB. (A Page 88)
2 Set the [TC GENE.] switch on the inner panel of the LCD to AREGENB.
When the camera recorder enters from recording standby mode to recording mode, it reads the time code already recorded on the SDHC card and records the new time code in continuation of that value.
The same data as the user’s bit already recorded on the SDHC card is recorded.
Memo :
●When the [TC GENE.] switch is set to AREGENB, the framing mode of the time code follows the settings in [Drop] of the [TC/UB] menu instead of the clip settings. (A Page 88)
Synchronizing Time Code with External Time Code Generator
This camera recorder comes with a time code input terminal ([TC IN]).
An external time code generator can be connected to the [TC IN] terminal to enable synchronization with the SMPTE/ EBU LTC time code.
Memo :
●After synchronization (slave lock) is complete, the
52