● Warning status is indicated by tally lamps and alarm tones.
(continued)● The front and back tally lamps of the camera recorder blink.
● Alarm tone is output from the monitor speaker or [PHONES] terminal.
The power status is displayed on the status and menu screens. If the battery or supplied voltage from the AC adapter is low, a warning will be displayed in red.
Memo :
●If you continue to use the camera recorder while the power warning is displayed, the camera recorder will stop automatically when the battery or supplied voltage from the AC adapter becomes lower.
●Alarm tone is not output during recording.
Note :
●If the battery in use is not a recommended one, the battery mark which indicates the battery level may not appear.
Status Screen
(A Page 102 [Status Screen in Camera Mode]) (A Page 108 [Status Screen in SD Card Mode])
(A Page 109 [Status Screen in IEEE1394 Input Mode])
1280x720 | 30/24 fps |
|
| 0 0 : 0 0 : 0 0 : 0 0 | ||
|
| |||||
24p HQ |
|
|
|
|
| MAX 123% |
|
|
|
|
|
| |
|
|
|
|
|
| MIN 45% |
|
|
|
|
|
| S.DTL |
A 100min |
|
|
|
|
| B |
B 100min |
|
|
|
| ND1/16 A<3200K> | |
STBY |
|
| RES | F5.6 AE+1 9dB 1/10000 | ||
|
| |||||
|
|
|
|
|
|
|
Enlarged status display on the LCD monitor (A Page 110)
CH1
CH2
DF
FREE
STBY | A | 1280 x 720 |
| |||
|
|
| min 24p HQ |
| ||
|
|
|
| |||
|
|
|
| B 100 min |
| RES |
Note :
●The remaining battery power and time are displayed as there are from the battery information. Accurate data may not be displayed according to the battery condition. Replace the battery as soon as possible when the remaining battery power and time are low.
Precautions for Batteries●Store the battery in a cool and dry place when not in use. Do not expose the battery to high temperatures (such as in a car under direct sunlight). This will cause battery leakage and shorten the battery life.
●Operating time is shortened if the battery terminal is dirty.
●If the operating time shortens drastically even after charging, the battery may be reaching the end of its life. Replace the battery with a new one.
Charging●Use up the charge completely before you charge the battery. If the battery is not fully discharged before charging, the battery capacity may drop after repeated cycles.
●If the battery capacity drops due to repetitive shallow charging and discharging, it may be recovered by using up the charge completely and then fully charging the battery again.
●If you charge the battery immediately after using while the battery is still warm, it may not be fully charged.
●It is recommended that you charge the battery in an environment between 10 f and 35 f. The battery may not be fully charged or the charging time may be prolonged if charged under low temperatures (below 10 f).
24