JVC LVT0900-004A Connecting Speakers, To connect an outdoor AM antenna, To connect speakers

English

AM antenna

1

2

Vinyl-covered wire

(not supplied)

3

AM loop antenna

(supplied)

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Connect the AM loop antenna to the AM LOOP terminals as illustrated.

3Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

To connect speakers

You can connect the speakers using the speaker cords.

1
2	Speaker terminals		3,4
		Black
Red	SPEAKERS		Red
	R	L
	CAUTION: R	L
Black	SPEAKER IMPEDANCE 4~16Ω		Black
	Speaker cord
Rear of the right			Rear of the left
speaker			speaker

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Hold the clamp of the speaker terminal.

3Insert the end of the speaker cord to the terminal. Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

4Release the finger from the clamp.

IMPORTANT

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•DO NOT connect more than one speaker to one speaker terminal.

– 7 –