Listening to External Equipment
You can listen to external equipment connected to the AUX/DVD jacks on the rear of the unit.
•First make sure that the external equipment is properly connected as follows:
DO NOT connect other equipment while the power is on.
| Right |
External equipment |
|
| Left |
| R |
| L |
| To AUX/DVD jacks |
SPEAKERS | |
R | L |
CAUTION: R | L |
SPEAKER IMPEDANCE 4~16Ω |
1 Press FM/AM/AUX (or AUX/DVD on the main unit) repeatedly so that “AUX” appears in the main display.
On the remote control:
•Each time you press the button, the source changes as follows:
FM AM
AUX
2 Adjust the volume level of the unit to “VOLUME 0.”
3 Start playing the external equipment.
•For operation of the external equipment, see the manuals supplied with it.
4 Adjust the volume level of the unit to your desired listening level.
5 Apply sound effects, if you wish.
• For how to apply sound effects, see page 14.
Adjusting the Audio Input Level
If the sound from the component connected to the AUX/DVD jacks is too loud or is not loud enough when changing from another source to “AUX” (without changing the volume level), you can change the audio input level through the AUX/DVD jacks.
1 Press FM/AM/AUX (or AUX/DVD on the main unit) repeatedly so that “AUX” appears in the main display.
On the remote control:
•Each time you press the button, the source changes as follows:
FM AM
AUX
2 Press and hold SET on the remote control for more than 2 seconds.
•Each time you press and hold the button, the audio input level alternates between “LEVEL 1” and “LEVEL 2.”
“LEVEL 1”: Select this when the sound is too loud (initial setting).
“LEVEL 2”: Select this when the sound is not loud enough.
To change the information shown in the main display
On the remote control ONLY:
Each time you press DISP/CHARA, the information in the main display alternates between the source indication and the clock indication.
•If an MD is inserted, the MD remaining recording time (“REC REMAIN”) is shown before the clock indication.
English