JVC CA-UXZ7MD, LVT0900-004A Setting the Clock, To turn off the clock indication power save mode

Setting the Clock

You can set the clock whether the unit is turned on or in standby mode.

On the remote control ONLY:

1 Press CLOCK/TIMER.

“0:00” appears in the main display with the hour digit flashing.

2 Press ¢ or 4 repeatedly to adjust the hour.

•When you press and hold the button, the hour digit changes continuously.

•You can also use the number buttons.

–To adjust the hour to 5, press 5.

–To adjust the hour to 12, press +10, then 2.

–To adjust the hour to 20, press +10, then 10 (or press +10 twice, then 0).

3 Press SET to set the hour.

The minute digit starts flashing.

•If you want to correct the hour again, press

CANCEL.

The hour digit starts flashing again.

4 Press ¢ or 4 repeatedly to adjust the minute.

•When you press and hold the button, the minute digit changes continuously.

•You can also use the number buttons.

–To adjust the minute to 5, press 5.

–To adjust the minute to 25, press +10, +10, then 5.

–To adjust the minute to 30, press +10, +10, then 10 (or press +10 three times, then 0).

5 Press SET to finish setting the clock.

The built-in clock starts.

To adjust the clock again

Once you have adjusted the clock, you need to press CLOCK/TIMER repeatedly until the clock setting screen appears in the main display (the hour digit starts flashing).

When you unplug the AC power cord or if a power failure occurs

The clock loses the setting and is reset to “0:00.” If this happens, set the clock again.

To turn off the clock indication (power save mode)

Press DISP/CHARA while the unit is in standby mode. “DISPLAY OFF” appears in the main display.

The clock indication goes off from the main display.

To turn on the clock indication, press DISP/CHARA again while the unit is in standby mode.

“DISPLAY ON” appears in the main display.

To check the clock time with tones

When the key-touch tone is activated (see “Turning On/Off the Key-touch Tone” on page 11), the unit lets you know the time using long and short tones in different pitches while the unit is in standby mode.

On the remote control ONLY:

Press DIMMER while the unit is in standby mode.

The time is represented as a four-digit number: two digits each for hours and minutes (ex. 2:58 = 0258). Each digit is distinguished by a different pitch of tone, and numbers are made up of long and short tones.

The following shows the details.

Differentiation of digits:

Do

Mi

Sol

Do

Higher

hours

Higher

minutes

digit

digit

Lower

hours digit Lower minutes digit

Representation of numbers:

Numbers

0

1

2

3

4

Tones

—

-

--

---

----

Numbers

5

6

7

8

9

Tones

*

*

*

*

*

•••••

•••••-

•••••--

•••••---

•••••----

* •••••: Five quick short tones

Ex.:

Hours

Minutes

2:58 = 0258 =

0

2

5

8

—

--

•••••

•••••---

Do

Mi

Sol

Do

English

– 12 –