Playing Back a Tape
You can play back type I tapes.
1 Push ) (PUSH OPEN).
The cassette holder opens.
) (PUSH OPEN)
Cassette holder
2 Put a cassette in with the exposed part of the tape down.
Cassette holder
3 Push ) (PUSH OPEN) gently to close the cassette holder.
4 Press TAPE 2 3.
The unit automatically turns on and the tape play starts from the front side.
•Each time you press the button, the tape direction changes as follows:
:Plays the front side (left to right).
:Plays the reverse side (right to left).
TAPE indicator
Reverse mode and tape direction indicators
Tape direction (left to right)
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to or . (See “To play both
To stop during play, press 7.
To
To
To remove the cassette, push ) (PUSH OPEN).
DO NOT push ) (PUSH OPEN) during tape play.
To play both sides—Reverse mode
You can set the deck to play just one side or both sides of a tape once, or both sides continuously.
Press REV.MODE.
•Each time you press the button, the reverse mode changes as follows:
: Plays back only one side (front or reverse). : Plays back the front and reverse sides once. : Plays back both front and reverse sides
continuously.
To change the information shown in the main display
On the remote control ONLY:
Each time you press DISP/CHARA, the information in the main display alternates between the source indication and the clock indication.
•If an MD is inserted, the MD remaining recording time (“REC REMAIN”) is shown before the clock indication.
• The use of the
•You can also play back type II and type IV tapes, however, the sound quality (tone) may not be reproduced properly.
English