Kenmore 385.151082 owner manual To Remove and Attach the Foot Holder, Extension Table

Extension Table

o Detaching the table

Pull the table away from the machine, as illustrated, for "free-arm" sewing of cuffs and sleeves.

o Attaching the table

Push the extension table until it snaps into the machine.

0	Extension table	(_	Tab
(_	Pin	®	Free-arm
(_) Hole

o Accessory box

Openthe cover of the accessory box toward you° Sewing accessories are conveniently located in the box

F

Changing Needle (_) Needle clamp screw

Needle clamp

[]Turn off the power switch°

Raise the needle to its highest position by turning the handwheel counterclockwise, toward you, and lowering the presser foot° Loosen the needle clamp s'crewOby turning it counterclockwise. Remove the needle from the needle clarnp(._).

[] Insert a new needle into the needle clamp(_)with the flat side to the rear.. When inserting the needle into the needle clamp (_, push it up as far as it goes. Tighten the needle clamp screw (_ firmly by turning it clockwise.

[]To see if the needle is good, place the flat side of the needle onto something flat (eg needle plate or glass).. The gap between the needle and the flat surface should be consistent+ Never use a bent or blunt needle

A damaged needle can cause permanent snags or runs in knits, fine silks and silkJike fabrics.

To Remove and Attach the Foot Holder f

(_) Thumb screw

(_) Foot holder Presser bar

•To remove

Remove the thumb screw (_by turning it counterclockwise with a screwdriver,

°To attach

Match the hole in the foot holder(_)with the threaded hole in the presser bar (_)o Fit the thumb screwOinto

the hole<,Tighten the screw Oby turning it clockwise with screwdriver_

®

Flat side

ILadopiano _ Needle

AiguiIle

tMgplatversAguja

[] I ,S

I

!

1

'N

\

J

10