3. Grasp under handle and gently close
door as far as it will shut. Pull door out
at bottom to remove.
4. Set door aside on protected surface.
To replace:
1. Fit hinge arms into slots in frame. Push in
at lower corners to insure that hinge arms
are fully engaged.
2. Open the door all the way.
3. Remove the door removal pins from
each hole.
4. Close the door.
NOTE: If the door does not operate freely,
you have not installed it properly. Repeat
Steps 1-4.
6
The oven vent
Hot air and moisture escape from the oven
through vent. The vent is above the oven
door. It is needed for air circulation. Do not
block the vent. Poor baking/roasting can
result.
Parts and Features
Removing the oven
door
For normal use of your oven, you do not
need to remove the door. However, you can
remove the door by following the instructions
in this section.
The oven door is heavy. Use both hands
to remove and replace the door. Do not lift
and carry the door by the handle. To remove
and replace the door you may need help.
To remove:
1. Open door all the way.
NOTE: Two 5⁄32" (4 mm) Allen wrenches or
two nails of similar diameter may be used if
factory furnished door removal pins have
been misplaced. Be careful not to damage
porcelain finish.
2. Insert small end of a door removal pin
into each door hinge.
Oven vent
Insert small end of
pin here
4452761Av04c52 1/11/00 8:18 AM Page 6