Kodak 6B8773 manual April 28

Using the Mirror Lock-Up with the Remote Controller

Replacing the Remote Controller Battery

Configuring your Camera

When using Mirror Lock-Up mode with the Remote Controller, use either AF or Manual focus to set the lens focus for the scene, then switch the lens to the MF position. If the lens is left in AF, the camera performs an autofocus when it receives the signal from the Remote Controller, and you will not be able to verify the correct focus.

1.Rotate the D-Dial to UP.

2.Set the camera to Remote Control mode.

3.Lightly press the Shutter button to set the focus, then set the lens switch to MF.

4.Aim the Remote Controller at the camera’s Remote Control sensor and press the Transmit button.

After a fixed time interval, the image is captured and the mirror returns home. See page 5-3for information on setting the time interval of the Mirror Prerelease function.

Use two CR 1220 3V Lithium coin type batteries.

1.Remove the bottom cover screws with a screwdriver.

2.Open the bottom cover and replace the batteries.

3.Replace the cover and tighten the screws. Be careful not to over-tighten.

Check the Remote Controller operation after replacing the batteries.

April 28, 2004 5-29