Kodak 6B8773 manual Time and Date, Using Setups on More than One Camera

Using Setups on More than One Camera

Time and Date

Configuring your Camera

Most settings are transferred when you load User Setups that have been saved to a card using a different DCS Pro SLR/c camera. The exceptions are Click Balance and Job Tracker settings, but you can work around these exceptions.

Before saving a User Setup on one camera and loading it on another:

1. Set up Click Balance identically on both cameras.

a. Capture the same image using both cameras, then perform the same Click Balance on both images (see page 7-3).

b.Save the Click Balance setting (see page 7-6). The settings must have the same names on both cameras.

c. Repeat for all need Click Balance settings.

2.Load identical Job Tracker files into the memory of both cameras (see page 5-10). The settings must have the same names on both cameras.

NOTE: If the Job Tracker file named in the User Setup is no longer in camera memory, Job Tracker will be disabled.

A time and date stamp is associated with each image file.

Inside your camera, a CR 2032 Coin Cell battery maintains the time and date for one to two years. If this battery loses its charge, you must replace the battery and reset the time and date.

1.Choose Time/Date from the Tools menu, then choose Time or Date.

2.If you chose Time, press the right or left side of the Five-way control to select hours, minutes, or seconds. Press the top or bottom of the Five-way control to change the value.

If you chose Date, press the right or left side of the Five-way control to select year, month, or day. Press the top or bottom of the Five-way control to change the value.

3.Press the OK button.

April 28, 2004 5-17