KODAK ESP 9200 Series All-in-One Printer

Connecting to a WPS wireless router

If your router supports Wi-Fi Protected Setup (WPS), you can use WPS Connect. WPS lets you configure your printer for a wireless network by pressing buttons or entering a PIN.

To connect to a network using WPS:

1.Press Home.

2.Press to select Network Settings, then press OK.

3.With WiFi Setup Wizard selected, press OK.

NOTE: The Wi-Fi radio turns on automatically when you select Wi-Fi Setup Wizard.

4.With WPS Connect selected, press OK.

5.Select one of two methods of connecting:

IMPORTANT: Before you press OK on the printer, make sure you know where the router's push button is, or where to enter the generated PIN. If necessary, consult your Internet service provider or router device manufacturer’s documentation for more information.

Pressing a button

Entering a PIN

 

 

 

 

 

 

 

NOTE: You will have two minutes to

a. Press

to select Generate

press or select the WPS

WPS PIN, then press OK.

button. It may be a button on

b. In your wireless router’s

the device or a virtual button

software, locate the PIN screen.

in the device’s software.

c. Enter the PIN you received on

 

a. With Push Button Configuration

the LCD into the PIN screen.

selected, press OK.

 

 

b. Press or select the WPS button for

 

 

your wireless router.

 

 

 

 

 

6.When the confirmation message appears, press OK.

If the printer is successfully connected, the Wi-Fi LED will stop blinking and stay on steadily.

If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking for more information.

7.If you haven’t yet installed the KODAK All-in-One Printer Software, go to www.kodak.com/go/aiodownloads and follow the on-screen instructions to install the software.

The printer with a wireless connection is listed as the name of the printer plus a number (for example, KodakESP9200+0069).

8.Enable the firewall that you disabled earlier.

www.kodak.com/go/aiosupport

7

Page 13
Image 13
Kodak 9200 manual Connecting to a WPS wireless router, Pressing a button, With Push Button Configuration