Konica Minolta A2 instruction manual Using the BUILT-IN Flash, Flash Range Automatic Operation

USING THE BUILT-IN FLASH

In low-light conditions or indoors, the flash is needed to illuminate the subject and reduce blurring through camera shake. The flash can also be used as a fill light in direct sunlight to soften harsh shadows. Always remove the lens hood when using the built-in flash; the hood may cast a shadow if mounted.

To use the flash, simply pull up the unit by the tabs on each side. The flash position must be set manually, and once up, the flash unit will always fire regardless of the amount of ambient light. The following indicators will appear in the upper left corner of the EVF and LCD monitors to show the flash status.

The red flash indicator appears when the flash is charging.

The white flash indicator appears when the flash is ready to fire.

After taking a picture, the OK indicator appears briefly if the flash properly exposed the subject.

Flash warning. In backlit situations, a white indicator appears to recommend the use of the flash.

FLASH RANGE - AUTOMATIC OPERATION

The camera will automatically control the flash output. For well-exposed images, the subject must be within the flash range. Because of the optical system, the flash range is not the same at the lens’ wide-angle position as it is at the telephoto position.

Wide-angle position	0.5m	~ 3.8m	(1.6 ft. ~ 12.5 ft.)
Telephoto position	0.5m	~ 3.0m	(1.6 ft. ~ 9.8 ft.)

36BASIC RECORDING