![](/images/new-backgrounds/1317904/317904229x1.webp)
DiMAGE_Z20_English_B412.qxd 04.12.27 16:57 Page 115
Pictures are
not sharp.
Focus signal is red.
Subject is too close.
The camera is in macro mode.
A special situation is pre- venting the autofocus system from focusing (p. 25).
Make sure the subject is within the autofocus range (p. 24) or use the macro mode (p. 35).
Cancel the macro mode setting (p. 35).
Use the
Pictures are | Slow shutter speeds | |
taken indoors | ||
result in blurred images | ||
or in | ||
when the camera is hand- | ||
situations with- | ||
held. | ||
out flash. | ||
|
Use a tripod, change the cam- era sensitivity to a higher set- ting (p. 59), or use the flash (p. 26).
While using flash, the pic- tures are too dark.
The subject is beyond the flash range (p. | Move closer to the subject or | |
change the camera sensitivity | ||
27, 59). | ||
to a higher setting (p. 59). | ||
|
The camera temperature rises with extended periods of use. Care should be taken to avoid burns when handling the camera, batteries, or memory card.
If the camera does not function normally or the system error message appears, turn the camera off, remove and reinsert the batteries, or unplug and reconnect the AC adapter. If the camera has become hot with extended use, wait for it to cool before removing or disconnecting the power supply. Always turn the camera off using the main switch otherwise the memory card may be damaged and the camera reset.
This manual contains information on products and accessories available at the time of printing. To obtain compatibility information on products not contained in this manual, contact a Konica Minolta service facility.