Kramer Electronics VP-770 user manual Selecting the PIP Source

7.2.3Selecting the PIP Source

To select a PiP source you have to set the VP-770to any of the PiP display mode

configurations and then select the desired input.

7.2.3.1Selecting the PiP Source via the Front Panel Buttons

Press and hold the PIP front panel button while pressing the input button of the required PiP source.

For example, to select CV 1 as the PiP source over DP as the main source, press the PIP front panel button while pressing the CV 1 front panel button (see Figure

26).

In this example, the DP button is illuminated and the CV 1 button blinks

Figure 26: CV1 superimposed over DP

7.2.3.2Selecting the PiP Source via the IR Remote Control Transmitter

Press the PIP button on the IR transmitter (the PIP front panel button is illuminated). Press the desired PiP source button on the IR transmitter (see Section 8.7).

7.2.3.3Selecting the PiP Source via the REMOTE Terminal Block Connector

See Section 8.6.

44 VP-770 - The Display Modes