Kyocera FS-1900 manual Maintenance Messages, Message Corrective Action

Indicators and Messages

Maintenance Messages

The following table lists maintenance messages that you can deal with by yourself. If Call service person appears, turn off the printer, disconnect the power cord, and contact your Kyocera Mita dealer.

Message		Corrective Action
Add paper (paper source)		The paper has run out. Supply paper according to the paper source displayed (paper
		cassette, MP tray, or optional paper feeder).
		Messages indicating the printer status (Ready, Please wait, Processing*,
		Waiting, and FormFeed Time Out*) are displayed alternately.
		* These messages will not appear if the number of copies is set to 2 or more.
Call service		The ATTENTION indicator turns on and the READY indicator goes off. Indicates a
person	F0	problem with the controller and the operator panel. Call a service person. The printer
		does not operate when this message is displayed.
Call service		The ATTENTION indicator turns on. Indicates a controller error. Call a service person.
####		The printer does not operate when this message is displayed.
Call service		The ATTENTION indicator turns on. Indicates a mechanical error. Call a service
####:0123456		person. 0123456 indicates the number of printed pages.
Cassette #		The paper cassette may not be propery inserted into the printer. Reinsert the paper
not loaded		cassette. The paper source number (#) is only displayed when there is an option paper
		feeder installed.
Check waste		The waste toner box is not installed. After installing the waste toner box, you should
toner box		be able to print. Replace the old waste toner box with the new one which is included
		in the toner kit. The message will also be shown if the waste toner box has become full.
	;	The waste toner box should be replaced when the message display eventually shows
		Toner low TK-50. See Toner Container Replacement on page 3-2.
Clean printer		Please clean the inside of the printer. See Cleaning on page 3-9.
Press GO		This message will be displayed when replacing the toner container after the message
		Replace toner TK-50is displayed. After cleaning the inside of the printer, press
		the GO key and the printer will be ready for printing.
	;	If Auto Continue is set to On, printing will be automatically resumed after a preset
		period of time.
Close duplexer		Open the option duplexer rear cover, then close tightly.
rear cover
Close		Open the left cover, then close tightly.
left cover
Close sorter		Open the sorter rear cover, then close tightly.
rear cover
Close		Open the stacker cover, then close tightly.
stacker cover
Close		Open the top cover, then close tightly.
top cover
Close paper		Open the paper transfer unit, then close tightly.
transfer unit
Face-down tray		The face-down output tray has become full (approx. 250 pages). You must remove all
paper full		printed pages from the face-down output tray. When the printer senses that the face-
		down output tray is empty again, it will continues printing into the face-down output

;tray.

;:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.

(Continued on next page)

4-7