Kyocera FS-1900 manual Write Information

	Operating the Storage Device
7	In this state, send the file from the computer to the printer.
	The file is written onto the storage device given a destination name
	(also referred to as a partition name) which the printer automatically
	assigns one after another as follows:
	DataS001 (first data),
	DataS002 (second data),
	DataS003 (third data)...
	In the example above, if the file TEST.TXT is the first data to be
	written onto the storage device, the destination name will be
	DataS001.
	As the printer receives data, the message display changes to
	Processing, then when the end of the data is received, the message
	display changes to Waiting.
8	Check that the message display has changed to Waiting, then press
	the GO key. This writes the file to the memory card and instructs the

printer to automatically print out a CompactFlash card write information page as shown below.

FS-1900 Page Printer

WRITE INFORMATION

Partition Type. Type of data written (currently only type 2 is supported). Partition Name. Name of data written.

Write Partition Length. Length (size) of the data written. Others. Additional information, such as error information.

When the write information page is printed, the message display returns to Ready.

If the writing was not completed successfully, an error code appears on the message display. For details, see Error Messages on page

4-10. If this happens, press the GO key. The message display returns to Ready.

1-85