Interface
1-78
Network Interface Parameters
This section applies to the printers having the option network card
installed.
To make your printer supports TCP/IP, Netware, and EtherTalk networks,
you will need to install the option network interface card in the printer and
make the proper settings as explained in this section.
Using the operator panel, you can:
•Activate or deactivate TCP/IP, NetWare, and EtherTalk
•Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
To confirm or change network card parameters, proceed as follows:
1Press the MENU key.
2Press the or key repeatedly until Interface > appears. One of
the interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Serial (when a serial interface board kit is installed)
Option (when a network interface card is installed)
3Press the ENTER key. A blinking question mark (?) appears.
4Press the or key repeatedly until Option appears.
5Press the ENTER key again.
Option
Interface
? Parallel
Interface